DescriptionProduct DescriptionStainless steel rods with a diameter of 1/2 inch (12.7mm).Optional thread configurations: One end M4 threaded hole one end M6 threaded hole; or one end M6 stud one end M6 threaded hole.Optional height range: 1 inch – 4 inches.Compatible with CA-A and CA-XC series rod holders.The Ø1/2-inch optical rods are essential components for building many rigid structures. Available in heights from 1 inch to 4 inches, they are compatible with our CA-A series rod holders, CA-XC series magnetic rod holders, and various structural accessories.ModelDiameterHeightWeightThread TypeMaterialPCAH1-AØ1/2 inch1 inch21.4gOne end M6 stud One end M6 threaded hole304 stainless steelPCAH1.5-AØ1/2 inch1.5 inches33.8gSame as above304 stainless steelPCAH2-AØ1/2 inch2 inches46.1gSame as above304 stainless steelPCAH2.5-AØ1/2 inch2.5 inches58.9gSame as above304 stainless steelPCAH3-AØ1/2 inch3 inches71.6gSame as above304 stainless steelPCAH3.5-AØ1/2 inch3.5 inches84.2gSame as above304 stainless steel ModelDiameterHeightWeightThread TypeMaterialPCAH1-SØ1/2 inch1 inch20.6gOne end M4 threaded hole One end M6 threaded hole304 stainless steelPCAH1.5-SØ1/2 inch1.5 inches31.9gSame as above304 stainless steelPCAH2-SØ1/2 inch2 inches44.2gSame as above304 stainless steelPCAH2.5-SØ1/2 inch2.5 inches56.7gSame as above304 stainless steelPCAH3-SØ1/2 inch3 inches69.2gSame as above304 stainless steelPCAH3.5-SØ1/2 inch3.5 inches82.4gSame as above304 stainless steelPCAH4-SØ1/2 inch4 inches94.8gSame as above304 stainless steelTechnical DescriptionThe Ø1/2-inch optical rods are essential components for building many rigid structures, and are compatible with our CA-A series rod holders, CA-XC series magnetic rod holders, and various structural accessories.The PCAH-S series rods have one end M4 threaded hole and the other end M6 threaded hole.The PCAH-A series rods have one end M6 stud and the other end M6 threaded hole.There is one Ø4.1mm through hole on the side of the rod body, through which a hex wrench can pass to provide greater torque when tightening components. A laser-engraved groove in the middle can be used for auxiliary alignment during center height adjustment.Multiple height options are available.AssemblyApplication ExampleEngineering Drawing DownloadPCAH-A-Engineering DrawingPCAH-S-Engineering Drawing
